If you inadvertently paint in a red area with a green brush, or vice versa, you can retouch that area with the correct brush color again until you get the correct areas chosen, and isolated. Draw with the required brushes on the areas as required. The red areas are for deleting and the green areas are for retaining The red areas are for deleting and the green areas are for retaining, as shown in Figure 3, below. By using the red and green brushes from the tool palette, you can select the area you want to delete or keep. ![]() ![]() This will prompt Fluid Mask to analyze your image again, and this might take a while. Once you change any parameters, you need to apply the changes. The parameters for the edge detection are set in a separate Edge Detection Options palette. The masking is entirely based on the detection of the edges.A separate Tool Options floating palette allows you to tweak parameters for any selected tool. You will also find a tool palette, which has different brushes used to create or modify masks.Since your image is already analyzed, you'll see the automatic edge detection in place represented by blue outlines (as shown in Figure 2, above) Workspace is to create and modify mask by clicking the show edges check box right at the bottom of the preview area.The main preview window has three tabs: Source, Workspace and Output. Thereafter, you will see the Fluid mask interface, as shown in Figure 2, below. ![]() This can take a while depending upon the size and complexity of the image.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |